EXP-15 VHDL IMPLEMENTATION OF BCD COUNTER WITH 7SEGMENT DISPLAY

AIM:
       To develop a BCD counter and display and its output in a seven segment display using FPGA kit.

APPARATUS REQUIRED:
      Xilinx V14.7 software
     FPGA Trainer kit

CONNECTION DIAGRAMS:

TRUTH TABLE:

FLOW CHART:

PROGRAMS CODE:

library IEEE;
use IEEE.STD_LOGIC_1164.ALL;
use IEEE.STD_LOGIC_ARITH.ALL;
use IEEE.STD_LOGIC_UNSIGNED.ALL;

entity code_m is
    Port ( clock : in  STD_LOGIC;
           reset : in  STD_LOGIC;
           seg : out  STD_LOGIC_VECTOR (6 downto 0));
end code_m;

architecture Behavioral of code_m is

begin
process (clock, reset)
variable bcd: STD_LOGIC_VECTOR (3 downto 0);
begin
if (reset='1') then
bcd := "0000";
elsif clock'event and clock = '1' then
if bcd < 9 then
bcd := bcd + '1';

else
bcd := "0000";
end if;
end if;
case bcd is
when "0000" => seg <= "0111111";
when "0001" => seg <= "0000110";
when "0010" => seg <= "1011011";
when "0011" => seg <= "1001111";
when "0100" => seg <= "1100110";
when "0101" => seg <= "1101101";
when "0110" => seg <= "1111101";
when "0111" => seg <= "0000111";
when "1000" => seg <= "1111111";
when "1001" => seg <= "1110111";
when others => seg <= "0000000";
end case;
end process;

end Behavioral;

SIMULATION OUTPUT:

PROCEDURES:

Step1: Open xilinx software > go to file > new project > create source file name> select specific folder> next >  select proper project settings> we use spartan 3E trainer kit.

Step2: next > finish > go to project > new source > select VHDL module > create file name> next > select input and output > next > finish> write program > if done write programs > click synthesis > right click> run.

Step3: go to user constraints > select I/O pin planning and right click > run > yes. wait few seconds. will open new tap like this.

Step4:  Assign input and output of the trainer kit pinouts > go to file > select save to constraints and close that tap. select implementation design and right click > run. select generate programming and right click > run. if you completed those three option with green tik. select configure device and right click >run. will open new tap. double click boundary scan >  ok. connect FPGA Trainer kit to PC system through parallel port or usb > right click centre point of the blue colour line > select initialize chain > then connected your FPGA Trainer kit.

Step5: open .bit file and load it > now you check the output result of the  FPGA Trainer kit.

NOTE: if you want image file > click print screen  > open MS paint > cnt +v > save
           if you want PDF file > file > print > select doPDF printer > create pdf file name + quality> ok